![]() ![]() Use the same soapy water or blade wash solution to immerse only the blade part of the clipper. If your clipper doesn’t allow you to detach the blades, don’t worry. It’s specially formulated to clean, sanitize, and expand the lifespan of all kinds of razor blades. You can also use a blade wash for the job. Step 3: Thoroughly wash the comb guide attachments with soapy water or liquid dish wash. Step 2: Use a small cleaning brush to clear off hair trimmings and other gunk from the blades as well as the top chamber of the clipper. Step 1: Take a screwdriver and unscrew the blades. Cleaning up the clipper blades is no big deal. The problem might be dirty, clogged blades. Sometimes, even after re-aligning the blades, they won’t simply cut smoothly enough. Step 4: Tighten the screws carefully, turn the clipper on and off a couple of times to check if it’s working alright. Doing so will prevent overlapping as well as keep the moving blades from slicing off your skin. So what you need to do here is position the top blade and the bottom blade parallel to each other, with the top blade teeth being at least 0.8 mm back from the tips of the bottom blade teeth. ![]() The vibration of the motor could cause the bottom blade to overlap the top blade, preventing the clipper from cutting properly. This could result in nicking as the clipper will cut dangerously close to the skin. Step 3: One of the most common mistakes people make while aligning the clipper blades is that they let the teeth of the small cutter blade sticking over the large comb blade. If you get that part right, the big fat tooth of the bottom blade will be on the extreme right-hand tooth of the bottom blade. Now, gently align the top blade with the bottom blade, making sure the extreme left-hand tooth of the top blade is covering or at the left of the first small tooth of the bottom blade. Yes, some lads do confuse them quite often, including me. First, you identify which one is the top blade or comb blade and which one is the cutting blade. If your clipper has a taper or blade adjustment lever, move it all the way up. Step 1: Semi-loosen the screws, just enough to be able to move the blades. I will walk you through the process of aligning your clipper blades, step by step: ![]() Sometimes, when resetting or zero-gapping the clipper blades, one side of the bottom blade might overlap the top blade while tightening the screws.ĭon’t let out a sigh of despair just yet because I’ve got the solution. If your blade is not cutting the way you imagined or snagging your hair more than what’s deemed normal, re-aligning the blade will probably do the trick. Crooked or Misaligned clipper blades prevent your clipper from functioning smoothly and using its full cutting potential. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |